*In order for factory warranty to be valid, must be a plug-and-play or a customer wiring harness must be purchased directly from PS Engineering. This is not required if product is installed by an Authorized PS Engineering Dealer.

But that's changed with the new PAR200A.  For aircraft owners who are on the fence about upgrading their audio or radio system,  the decision has just gotten easier.

The PAR200A has it all. Starting off with a full featured audio selector panel, it also has our 4-place stereo IntelliVox® intercom with Bluetooth® interconnectivity, a 10 Watt Speaker Amplifier, and last but least, the PAR200A is your control panel that accesses a  very capable 2280 channel VHF aviation radio. (Selectable 8.33KHZ)

We partnered with Trig Avionics, LTD, a company that has become renown for great radio and transponder designs. The TY91L remote mounted com radio has been designed to produce a minimum of 6 watts of RF output power.

The radio has excellent radio selectivity and AGC specifications that makes both transmit and receive audio punch right through. Clear radio communications has been the trademark of Trig Avionics, LTD. 

The radio also has automatic radio squelch which assures that the radio trip level is always optimally set. 

And to add a bit of flexibility, we have included our highly lauded  Bluetooth® technology. Pairing of phones or Bluetooth® enable audio devices is easily achieved for wireless entertainment. 

Telephone calls can be distributed in three different ways (as determined by the ICS switch). The pilot can make a private phone call, the crew can make a call, or all on board can be in on the conversation. 

And for music inputs, there are two different inputs and two types music distribution. The standard configuration allows music 1 (or Bluetooth® to go to the crew while the passengers hear music 2. The other selection allows music 1 (or Bluetooth) to go to all headsets. 

Monitor Mode allows the pilot  to hear the Active and Standby frequencies at the same time. When the Active frequency becomes active, the Standby frequency will be muted. Along with the Monitor Function,  the PAR200A also has our patented Swap mode, allowing the com radios to switch from Com 1 active to Com 2 active, and visa-versa.

Up to 5 discrete radio frequencies can be stored in non-volatile memory for quick dial up as well as being able to swap from and Com 1 to Com 2 by way of a yoke mounted switch. 

The construction of this radio could be considered "industrial strength".  The quick dismount of the radio from it's mounting bracket makes inserting the unit a cinch. Even the RF connector hasn't been spared for longevity, using a TNC connector versus the typical BNC type. 

All connectors are included with the radio.

The PAR200A has fully independent power supplies so you can power up the radio or audio panel individually. And if you have a  second Com or Navcom,  you can use it as Com 1 and use our remote radio as Com 2.

The PAR200A uses the same tray and connector as the GMA240, GMA340, PMA8000 series. However, there is additional wiring that is required to interface the Com Radio to the audio panel.

* GARMIN is a registered trademark of GARMIN, Ltd. PS Engineering, Inc. is in no way affiliated with GARMIN, LTD.  

PAR200A LIST  PRICE: LIST $2995