These were on a homebuilt 2 seat Jodel that came fromCanada. I think these are built to the Jodel plans, but I can't confirm that. These telescopic landing gear legs install on the front of the spar and bolt to the spar. The opening for the spar is 8" tall. They seem to have a coil spring in them to give them some travel and rebound, but I don't think there's any type of dampening. The welded-on axles have a 1.25" diameter and had 6" wheels installed. The legs weigh right at 24-25 lbs each. They're 28 inches from the bottom of the spar mount to center line of the axle. There is no name or part number on the legs or scissor links. There is considerable surface rust on them in some places, but they would mostly clean-up well if sand blasted. There's enough rust that I'd call it pitted in places at the top of the tubes and on the kind-of triangular straps that bolt to the spar. Some repair, replace, or patch may be needed there, your call on that. I can get you any detail photos you need. Any tools, fixtures, or parts in the background are of course not included. Only the two landing gear legs are for sale.